Micposi Leveling System

Micposi Specifications  Micposi Accessories  Case Studies  Micposi Users  Order Form  Downloads  

About Micposi

Conventionally, "machine leveler" means a "leveling foot" that screws into the bottom of machines and rests on the floor. MICPOSI was designed not only to level but to anchor and lock one component against another.

Its typical use is the leveling of sub-assemblies to a main assembly with a thousandth of an inch accuracy to each other, while often eliminating the need for machined pads.

They are used in diversified industries such as laser optics, tube bending machines, compressors and semi-conductor equipment.

Two slots allow upper and lower segments to compress and lock within the female thread without marring the top surface (With use of lock washer).

Micposi can be used without projecting above the base plate so moving components can pass over it. Just select the proper thickness of base plate or use an adaptor bushing

Micposi adjusts and locks from the top. The middle part of the base plate can be supported without the need to access lock nut or spacer.

You can drill, tap and install Micposi with the base plate in place. For precise placement use the optional "Pilot Drill Bushing" and "Tap Drill Bushing".

Micposi can be installed upside-down and side-ways, as well as right-side-up.

Micposi is self leveling.